Table of Contents
1. General Safety Requirement...........................................................1
2. Safety Terms and Symbols..............................................................2
3. General Inspection........................................................................... 3
4. Quick Start .........................................................................................4
Front Panel Overview
..............................................................................................................4
Rear Panel Overview
.............................................................................................................. 5
Power On
...................................................................................................................................5
User Interface
........................................................................................................................... 6
5. Panel Operation................................................................................ 7
Channel Setting
........................................................................................................................ 7
Waveform Setting
.....................................................................................................................7
Output Sine Wave
............................................................................................................ 7
Set the frequency/period
........................................................................................ 8
Set the amplitude
..................................................................................................... 8
Set the offset
.............................................................................................................8
Set the high level
..................................................................................................... 9
Set the low level
....................................................................................................... 9
Set the Phase
........................................................................................................... 9
Output Square Wave
.......................................................................................................9
Output Ramp Wave
....................................................................................................... 10
Set the symmetry
................................................................................................... 11
Output Pulse Wave
........................................................................................................11
Set the pulse width/duty cycle
............................................................................. 12
Set the rising time
.................................................................................................. 14
Set the falling time
................................................................................................. 14
Output Noise Wave
........................................................................................................14
Output Arbitrary Wave
...................................................................................................15
Select build-in wave
...............................................................................................15
Store
.........................................................................................................................20
Generate Sweep (Sweep)
.................................................................................................... 21
Generate Burst (Burst)
.......................................................................................................... 23
Output the Modulated Waves
.............................................................................................. 25
AM (Amplitude Modulation)
..........................................................................................25
FM (Frequency Modulation)
.........................................................................................27
PM (Phase Modulation)
................................................................................................ 28
FSK (Frequency Shift Keying)
..................................................................................... 29
Utility Function Setting
.......................................................................................................... 30