To Next PageTo Next Page
Need help?Do you have a question about the Owon DGE1000 Series and is the answer not in the manual?
General| Brand | Owon |
|---|---|
| Model | DGE1000 Series |
| Category | Portable Generator |
| Language | English |
Explains terms like Warning, Caution used in the manual.
Explains terms like Danger, Warning, Caution appearing on the product.
Lists safety symbols found on the product.
Instructs on checking for transportation damage upon receiving the instrument.
Guides on verifying all supplied accessories are present and undamaged.
Details how to check the instrument's appearance and functionality.
Provides a visual and descriptive guide to the instrument's front panel controls.
Details the components and connectors on the rear panel of the instrument.
Steps for connecting power and turning on the waveform generator.
Explains the layout and functions of the instrument's user interface.
Enabling channels and selecting basic waveform types (Sine, Square, Ramp, Pulse, Noise).
Detailed steps for setting sine wave parameters: frequency, amplitude, offset, phase.
Steps for configuring square wave parameters: frequency, amplitude, offset, phase.
Steps for configuring ramp wave parameters including symmetry.
Setting pulse wave parameters: frequency, amplitude, offset, phase, width, duty, rise/fall time.
Setting parameters for the white noise waveform output.
Selecting and setting parameters for system built-in or user-defined arbitrary waveforms.
Guide to choosing from the generator's library of 160 built-in waveforms.
Loading and saving custom waveforms to/from the instrument.
Configuring sweep parameters like sweep time, type, start/stop frequency, and trigger source.
Setting up burst pulse trains, including N-cycle and infinite burst modes.
Configuration of Amplitude Modulation (AM), Frequency Modulation (FM), Phase Modulation (PM), and FSK.
Setting up Amplitude Modulation parameters for the carrier and modulating waves.
Setting up Frequency Modulation parameters for the carrier and modulating waves.
Setting up Phase Modulation parameters for the carrier and modulating waves.
Setting up Frequency Shift Keying modulation parameters.
Adjusting screen brightness level.
Configuring automatic screen dimming and power saving.
Setting the display format for numbers.
Managing instrument display language and audible alerts.
Configuring USB connection for remote communication.
Resetting the instrument to its default configuration.
Steps to install the Waveform Editor software and drivers.
Resolving problems with a black or blank screen.
Troubleshooting when measured amplitude does not match display.
Lists available standard and arbitrary waveform types.
Specifies frequency ranges and resolution for different waveforms.
Details output amplitude ranges, accuracy, and resolution.
Describes sine wave characteristics like bandwidth flatness and distortion.
Specifies characteristics for square, ramp, pulse, noise, and arbitrary waves.
Details parameters for AM, FM, PM, and FSK modulation.
Specifies parameters for sweep and burst generation.
Covers display, power, environment, and mechanical details.
Lists all included accessories with the instrument.
Provides guidelines for maintaining and cleaning the instrument.
