Owon DGE1000 Series User Manual

5
.
Panel Operation
7
5. Panel Operation
Channel Setting
Press On/Off on the front panel to turn on/off the corresponding channel
output. The backlight of the button will light up when it is set to output.
Waveform Setting
Sine, square, ramp, pulse, noise or arbitrary waves can be set and output.
Press the waveform selection button on the front panel: sine , square
, ramp , pulse , noise , arbitrary wave , and enter the
corresponding waveform setting interface. The waveform is different and the
parameters that can be set are different.
Output Sine Wave
Press , the screen displays the user interface of the sine wave. The Sine
waveform parameters can be set by operating the Sine setting menu on the
right.
The sine wave menu includes: Frequency/Period, Amplitude/High Level,
Offset/Low Level and Phase.The menu can be operated by the menu
selection button on the right.
Figure 5- 2：Sine wave user interface

Owon DGE1000 Series Specifications

General

Brand	Owon
Model	DGE1000 Series
Category	Portable Generator
Language	English