Owon DGE1000 Series - Set the Pulse Width;Duty Cycle

5
.
Panel Operation
12
Offset/Low Level, Phase, Width/Duty , Rise and Fall.
To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, Phase,
please refer to Output Sine Wave on page 7.
Figure 5- 7
：
Pulse wave user interface
Set the pulse width/duty cycle
Press NextPage softkey,and then press Width/Duty softkey to confirm
whether the Width menu item is highlighted;if not,press Width/Duty softkey to
switch to Width.In Parameter 5 of Figure 5- 7, a cursor appears in the
parameter value. Turn the knob to change the value directly, or use the
numeric keypad to input the desired value and choose the unit.