12
5
Mounting
The Power Clamp has a mounting bracket for mounting purposes.
1. Use the mounting bracket as template to mark the two holes on the
wall for installing screws.
2. Screw the mounting bracket onto the wall according to marked
location. Install wall plugs if necessary.
3. Locate the hooks of the mounting bracket and line up the hooks
with the mounting holes on the Power Clamp. Fit the hooks into the
mounting holes as the picture below. Installation is now completed.
6
FAQ
1. Congure the network in AP mode.
1. Reset the device in EZ pair mode, it will switch to AP mode. The
indicator on your device will blink slowly.
2. Then switch the network configuration mode to AP mode at the
upper right corner of the APP when you add the device.
To Next Page
Loading...
