move the cursor position; short press the Memory function key on the front
panel to exit the parameter setting status；
（5） In the non-parameter setting state, press the knob for 3 seconds to confirm,
enter the "List Waveform Output Mode", and at the same time, switch back to
the main interface;
（6） Long press the Memory function key on the front panel for 3 seconds to exit
the "List waveform editing interface".
4.5.2 List waveform output
To perform List waveform output, the steps are as follows:
（1） Follow the steps described in 1.1 to edit the List waveform;
（2） Enter "List output mode", at this time, the first point of the List waveform
pre-output is displayed in the upper right corner, such as "List1";
（3） Short press the On/Off function key on the front panel, the instrument will
output according to the List editing time sequence, and the status bar at the
top of the main interface will display the current List output point and the
countdown of the duration of this point;
（4） In the List output mode, press and hold the Memory function key on the
front panel for 3 seconds to exit the "List output mode".
To Next Page
Loading...
Need help?
General
