number or curve.
Number
Press the Display function key to set the display mode to Number. When the
power supply is powered on, the default display mode is Curve.
Curve
Press the Display function key to set the display mode to Curve.
5. Troubleshooting
1. The instrument is powered on but no Display.
⚫ Check if the power is connected properly.
⚫ Check if the fuse which is below the AC Power socket is used
appropriately and in good condition (the cover can be pried open with a
straight screwdriver).
⚫ Restart the instrument after the steps above.
To Next Page
Loading...
Need help?
General
