3. Set the sensor configuration file.
Press the Load softkey, choose KITS90 or Pt100.
4. Set the display.
Press the Display softkey to set the display mode of the result.
Temp: only the temperature value will be displayed;
measure: only the measurement value will be displayed.
All: both the temperature value (on the main display) and the measurement value
will be displayed.
5. Set the temperature unit.
Press the Unit softkey to display temperature in ℃ (degrees Celsius), ℉ (degrees
Fahrenheit), or K (Kelvin).
The conversion relations between these units are:
℉ = (9/5) ×℃ + 32
K ≈℃ + 273.15
6. Set the relative value.
Press the Rel softkey to turn on or off the relative operation. For relative operation,
the multimeter subtracts the pre-specified value of REL operation from the actual
measurement result and displays the result. See page 26, Relative Value.
To Next Page
Loading...
