Pattern being played and Repeats of that pattern in that position, up until infinite repeats of the
pattern (after 19 you will see the infinite icon displayed).
–––––––––––––––––––––
To set the Arranger ready for playback press Shift + Arranger, you’ll see “Arranger ON” on the
screen. The Arranger then ready for playback. Turn OFF Arranger from playing with the same
combination of buttons.
–––––––––––––––––––––
On the main screen you can see on the right the countdown for each arrangement track pattern to
change to the next one and a progress bar of it. If the current pattern is looped a round arrow will
indicate this.
Songs are saved states of the Arranger, that means you can save and recall structures of sequenced
patterns per Project. Any unsaved changes to the patterns being played won’t be saved on your
Songs.
Any time you save a Pattern or a Project, the current Song will be also saved.
IMPORTANT: Be sure to save all your changes in your patterns because every time a new pattern is
automatically loaded by the arranger, changes are lost.
CLIP LAUNCH
Hold Shift and press one pad per arrangement track to launch that pattern when the current one
ends. This is helpful to have patterns looping until you want to launch a new part of your song in real
time.
To Next Page
Loading...