FUNCTION BUTTONS
· TRANSPORT
The following behavior applies to Internal Sync:
Rec enables recording from the Keyboard view or from any MIDI input..
Stop halts and resets all the Sequencers to step 1.
Play/Pause works as expected.
Recording: the sequencers will receive the incoming MIDI information depending on the
MIDI In channel filtering configuration option.
If MIDI In channel filtering is ON, every sequencer will listen to its own MIDI channel. If OFF, the
selected sequencer will listen to any channel.
Press Shift + Rec to access Recording Menu, parameters from left to right:
Countdown before starting recording. It only works when the active
sequencer is inactive. Otherwise it will start recording immediately.
Time Quantization. Percentage of quantization to the division of the
selected sequencer. To apply the quantization, a confirmation by
pressing the same encoder is required.
Overdub, recording behavior. If ON, the sequencer will keep the
already existing notes adding new ones. If OFF, the transport bar will delete the events of the
sequencer that are in its path.
Looping, 1-Shot or Extend.
Three different behaviours that work as follows.
- Looping will continue recording events inside the actual track length; the initial and end steps
will remain unchanged.
- 1-Shot will stop the recording once the transport bar reaches the final track step.
- Extend, the length of the track is increased until you stop the recording or the transport bar
reaches the maximum possible track size. This behavior allows MIDI Live Looping using
external MIDI input or the OXI One Keyboard layout.
· Long press Shift + Play for more than 3 seconds to take a rest from sequencing ;)
Shift + MUTE opens the Nudge menu - NOT IMPLEMENTED
In Config menu you can choose to enable Rec Listen, this way pressing Rec arms the track and start
recording once a note is activated, being in One Keyboard or any MIDI input - NOT IMPLEMENTED
To Next Page
Loading...