ASSEMBLY (cont.)
3. Fully loosen the chain tensioning screw (18) as far as you can anti-clockwise (refer
below left picture).
4. Now remove the chain drive cover nut (17) and remove the chain drive cover (19),
refer below right picture).
5. Once the chain drive cover (19) has been
removed, the transport-protecting spacer (26)
must be removed and disposed of so that the
chain bar can be positively located.
6. Place the guide bar (14) in position over the threaded stud and the two screw
heads which are on either side of the stud. The guide bar should remain upright
when you let it go, be careful not to knock it off the screw heads.
7. Place the chain (13) around the drive sprocket wheel (20) with the chain teeth
direction matching the link icons shown on the guide bar (refer above right picture).
If not in the right direction, the chain will not cut. Fit the chain around the guide
bar and ensure the chain is fitted above the chain guide and NOT below.
Remove
Spacer
* Direction of chain teeth should
match the tooth icons on the bar.
Chain Guide
Stud
11
To Next Page
