OPERATION (cont.)
16
8. When restarting the engine when it is still warm, set
the choke control (1) to the START position. Hold
the chainsaw securely on the ground and pull
vigorously on the recoil starter (9). Allow the engine
to run for a few moments with the throttle trigger
(4) pulled slightly.
9. When the engine is fully warm, pull on the throttle
trigger (4). The choke control (1) will fully retract to
the RUN position.
10. When ready to start cutting, release the brake, by
pulling the front guard (6) back firmly towards the rear of the saw.
Stopping the chainsaw
1. Release the throttle trigger (4).
2. Set the on/off switch (11) to Off (the O position).
Checking the chain bar oil supply
Run the engine at medium speed and check that
the chain splatters a thin line of oil which can be
seen on the ground when the bar is pointed
downwards. This is normal. It may take 15-30
seconds for this to happen if this is the first time
the chainsaw has been started. If there is no line
of chain oil, stop the motor immediately and
investigate the cause. The chain bar oil tank could
be empty or the oil supply to the chain blocked.
This may require removal of the bar and checking
that the upper oil hole in the bar is clear of any blockages.
Adjusting the carburettor
The carburettor is factory set and should not require adjustment.
Changes in operating conditions may require fine tuning of the carburettor. A
special tool is required for making these adjustments. Contact Ozito Customer
Service for advice and instructions.
Aus: 1800 069 486
NZ: 0508 069 486
RUN
START
CHOKE
To Next Page
Loading...
