cc
Cubic Centimeters (the standard measure of displacement in Europe and Asia)
n
o No load speed
/min Revolutions or reciprocation per minute
dB Decibel level Electrical Emissions Conformity (EMC)
Read the manual prior to use
Wear safety boots
Wear safety gloves
Warning Be aware of moving branches
Pull recoil starter to start motor
Do not use chainsaw when
only holding with one hand
Use both hands when using chainsaw
Use eye, ear, head and breathing
protection when operating the chainsaw
Fuel inlet
(Position: under the fuel tank cap.)
On/Off
(Position: next to the oil tank cap)
Setting the on/off switch to Off,
stops the engine immediately
Choke control
(Position: next to knob on the filter cover)
Chain brake released (hollow arrow) and activated (solid arrow)
(Position: right side of machine, on chain drive cover)
CHOKE Start position (when engine is cold)
START Start position (when engine is warm)
RUN Run position
Chain oil inlet
(Position: next to the oil tank cap)
H High run adjustment screw
L Low run adjustment screw
T Idel adjustment screw (Position: left side of
machine close to pull start handle)
To Next Page
Loading...
