14
ASSEMBLY (cont.)
• Do not use fuel mixtures that have been left standing for one month or more,
they can cause clogging of the carburettor.
Before storing the chainsaw for an extended period, empty the fuel tank, clean it
then run the motor to empty the carburettor.
Note: Do not discard an unwanted fuel container with household waste. It must
be taken to an authorised repository site.
Mixing fuel (35:1 mixing ratio)
1. Measure out the quantities of petrol and oil to be mixed.
2. Put some of the petrol into a clean, approved fuel container.
3. Pour in all of the oil and mix well.
4. Pour in the rest of the petrol and again mix well (at least one minute).
5. It is very important to mix the two ingredients properly to prevent unnecessary
engine wear.
6. Make sure that the container is clearly labelled that it is “35:1 2-stroke” mixture.
Fuelling the chainsaw
1. The engine must be stopped
and cool. Place the chainsaw on its side with the fuel tank cap facing upwards.
2. Make sure that the fuel mixture is well mixed.
3. Remove the fuel tank cap (21).
4. Fill the fuel tank to about 80% of its capacity.
5. Fasten the fuel cap (21) securely and wipe up any fuel spillage around the machine.
Note: 1 litre of 2-stroke fuel = 28.5ml of 2-stroke oil & 971.5ml of unleaded fuel.
5 litres of 2-stroke fuel = 143ml of 2-stroke oil & 4.857L of unleaded fuel.
Adding chain bar oil
Warning! Never start work unless the chain and bar are lubricated.
1.
Place the chainsaw
on its side with the
chain bar oil tank cap
(24) facing up.
Untwist and remove
the chain bar oil tank
cap (24).
2. Fill the tank to 80%
capacity with chain oil.
To Next Page
