Need help?Do you have a question about the Pace MSP 995 and is the answer not in the manual?
General| Temperature Range | -40 to 85°C (-40 to 185°F) |
|---|---|
| Type | Electro-pneumatic |
| Operating Temperature | -40 to 85°C (-40 to 185°F) |
| Input Signal | 4-20 mA |
| Supply Pressure | 1.4 - 7 bar (20 - 100 psi) |
| Protection | IP66, NEMA 4X |
| Enclosure Rating | IP66, NEMA 4X |
| Housing Material | Aluminum |
Introduces the Pace MSP995 Dish Positioner and its function with a motorised dish and Pace Receiver.
Provides guidance on using the manual and essential safety instructions before operation.
Essential safety warnings for operating the satellite dish positioner, emphasizing electrical hazards.
Details on connecting the unit to the mains supply and associated safety precautions.
Instructions for connecting mains plugs, including fuse replacement and rewireable plugs for UK and Europe.
Explains the three operational modes: normal, program, and set limits, with LED indicators.
Details the function of each key on the Dish Positioner handset for various operational modes.
Visual diagrams of the unit's front and rear panels, illustrating ports and controls.
Explains the function of the front panel buttons and their operation in different modes.
Explains how to alter previously set East and West limits to change the dish panning range.
Describes the "out" error message when a position is outside the set limits.
Instructions for assigning satellite position numbers, including using a Pace satellite receiver.
Describes using the receiver's frequency scan mode to find channels and set up positions.
Details how to adjust polarity (skew) values for optimal signal reception.
Advises setting up separate positions for Horizontal (H) and Vertical (V) polarities.
Explains factory-set skew values and how to change them for fine-tuning.
How to operate the positioner using a Pace satellite receiver's handset.
How to operate the positioner directly using its own handset.
Instructions on how to stop the dish movement temporarily while in operation.
How to check the current dish position via the STATUS key.
Explains how to enter and exit standby mode for the positioner.
Procedure to restore programmed positions after a power interruption.
Resets the unit to factory defaults, erasing all settings and positions.
Instructions for removing programmed satellite positions.
Explains common error messages like "Out", "Not Set", "End", "Del", "ERR", "LE1", "ER1".
Instructions for connecting the dish actuator, covering reed and optical types.
How to connect an electromagnetic or mechanical polariser to the unit's rear panel.
Details on connecting the positioner to a Pace satellite receiver via SCART for integrated control.
Specific instructions for using the positioner with other Pace receiver models like 9000/9200 series.
Lists the technical specifications of the MSP995 Dish Positioner, including power, dimensions, and environmental ranges.
Details the specifications for the polariser's mechanical and electromagnetic functions, including supply and control.
Provides a table of pin assignments for both the Receiver Interface and External Decoder SCART connectors.
Definitions of key terms related to satellite TV reception and the positioner, such as LNB, SCART, Polarisation, and Actuator.
To Next Page