System Operations Manual
www.paceworldwide.com
Page 34 of 50
Maintenance beyond this should only be completed by a qualified PACE service technician.
10. Heater Replacement
It is recommended you return the machine to PACE, Inc. or call a PACE representative to replace
the heater element.
CAUTION: REMOVE POWER CORD FROM MACHINE.
Removal Procedure
1. Remove the nozzle and vacuum pick.
2. Remove the 4 hex socket head screws on each rail cover on the left and right sides of the
heater.
3. Once the rail covers are removed, reinstall one of the
hex head screws in the rails to avoid the accidental
removal of the reflow head assembly from the rails.
This will avoid the loss of the ball bearings. This may
also be achieved by installing the metal retainers on
the tops of the rails.
Requires 9/64”
hex wrench
Figure 22
Figure 23
To Next Page
Loading...
