Pacojet 4 - Electrical Power Supply

5
© Pacojet International AG 2022
25. There is a risk of the baseplate falling when removing it from the
device.
26. Under no circumstances may products be processed by the
device or added in for processing if they release gas during
processing, which can cause an uncontrolled pressure increase
in the pacotizing
®
beaker (e.g., liquid nitrogen (N) in pure form or
carbon dioxide (CO
2
) in bound form for carbonation).
27. Never use liquid nitrogen (N) to cool/freeze the pacotizing
®
beaker. The pacotizing
®
and protective beaker could otherwise
break, resulting in eye injury due to ejected parts. The base of the
pacotizing
®
beaker can become loose.
28. Do not use a pacotizing
®
beaker with a heavily bulged base.
29. Note: Remove the protective beaker if the device will not be used.
ELECTRICAL POWER SUPPLY
30. Disconnect the device from power if it will be unattended for an
extended period.
31. Do not tamper with any safety switches!
32. Do not open the device housing or any covers that are
permanently fastened.
33. Do not operate the device if any components are defective or have
been tampered with. Should the device fail to function properly,
immediately turn it off, disconnect it from power, and contact your
service partner.
34. The power cable may only be replaced by authorized service
personnel.
35. Only use the device if it is free of all technical defects.
36. Only operate the device at the voltage specified on the label.
37. Check the device and power cable for external damage before
each operation.
38. Do not immerse the device in water or liquid. Do not expose the
device to increased moisture.
39. Disconnect the device from power if it will not be used for an
extended period.
40. Never touch the power cable or plug with wet hands.