PACOM SmartIP-32PD - Firmware Upgrade; Record Setup; General Record Settings

Part 3 - Conguration
53
Upgrade
Select Firmware Upgrade to display the USB search
window.
Select the corresponding upgrade package from the
storage device connected to the NVR's USB port.
After selecting an upgrade package, select Apply to
upgrade the camera.
t If an upgrade attempt fails, an upgrade failure
message will be displayed. Refer to Error Code
Types on page 87 for more details.
t The camera will reboot after the upgrade and then
reconnect automatically.
t Current software version is not checked when
upgrading a network camera.
Record Setup
Refer to the Menu Use on page 36 for basic
information on using the Setup menus.
General
Congure general recording settings.
t Recycle: When the recording disks become full,
the system overwrites existing data with new data,
starting with the oldest rst. If Recycle is disabled,
recording will simply stop when the recording disks
reach their maximum capacity.
t Record Audio: The camera will record audio along
with video.
t Event Record Dwell: If linked recording is designated
as an event-triggered action, recording takes place for
the duration specied under this setting.
t Auto Deletion: Congure this option to delete
recording data automatically after the specied
number of days has elapsed. Select between 1 day
and 999 days.
To disable Auto Deletion, select Never. If enabled,
recording data will be stored on the NVR for
the specied number of days and then deleted
automatically. Expired recording data are deleted
automatically at midnight and will be deleted even if
the system reboots or the Auto Deletion setting has
been changed.