17
For Protocol, we will need to select either TCP and UDP. This will depend on the application you
are using—TCP is recommended for web-browsing and emails, while UDP is recommended for
VoIP and online games. In our example, we will select TCP. The External Service Port is the port
that the traffic is coming into the router from. We will use port 80 in our example, which is most
often used for HTTP. We will confirm it in the right-hand side box. Map to Port refers to the port
that the traffic will use when it enters the internal network. In our example we will use 80. We
will also enter it in the right-hand side box.
The complete virtual IP will look like the following. Click OK.
3. You should now see your Virtual IP listed.
4. Now we will need to create a policy for this Virtual IP. Navigate to Policy & Objects->Policy-
>IPv4. Click Create New.
To Next Page
Loading...
