Pakedge Device & Software K60D - Dual WAN Redundancy

26
2. Set the Distance field to 5. Click OK.
3. If wan1 is using a static IP, navigate to Router->Static->Static Routes. Double-click on the static
route that you created.
4. Set the distance field to 5. Click OK.
5. If wan2 does not use DHCP, skip to step 7. If wan2 uses DHCP, navigate back to System-
>Network->interfaces. Double click on wan2.
6. Set the distance field to 10. Click OK.
7. If wan2 is set to a static IP, navigate to Router->Static->Static Routes. Double-click on the static
route that you created to get internet access for this wan port.
8. Set the distance field to 10. Click OK.