WAP-VKIT User Manual
25
WPA-
PSK/Mixed
(WPA-
Personal)
WEP Key
Static WEP Key Index
Shared Key
Authentication
In the Security Profile Name text box, type a name for the security profile.
In the L2 Modes Allowed area, click in the box to select the type of security required for
your ESS (use the setting from the table’s L2 Mode). This will determine which other
options are active in the view.
Use the table to set the remainder of the settings, based on the L2 mode you selected.
Static WEP Key Notes
In the WEP Key text box, type a key that is within the contraints of the WEP type you
selected:
i. A WEP64 key must be 10 hexadecimal digits (the hexadecimal string must be
preceded by 0x), or 5 printable alphanumeric characters. For example,
0x619B947A3D is a valid hexadecimal value, and wpass is a valid alphanumeric
string.
ii. A WEP128 key must be 26 hexadecimal digits (the hexadecimal string must be
preceded by 0x), or 13 printable alphanumeric characters. For example,
0xB58CE2C2C75D73B298A36CDA6A is a valid hexadecimal value, and
mypass8Word71 is a valid alphanumeric string.
WPA-PSK/WPA2-PSK Notes
iii. In the Pre-shared Key box, type a key. The key can be from 8 to 64 ASCII
characters, or 64 hex characters. Hex keys must be prefixed with 0x or the key will
not work.
When you finish, click OK.
To Next Page
Loading...
