20 1-2017
Translation
NOTE ! The protective net for the splitting chute shall be closed during start-up of
the electric motor.
3.12 Electric heater for oil tank
A 300 W electric heater carpet with adhesive tape attachment and a thermostat is availa-
ble as an option for the hydraulic oil tank. The starter comes as standard equipped with an
operating switch for the heater, Fig 8 E. Heating the oil for 1-2 hours is sufficient to enable
smooth starting.
The size of the heater carpet is 200 x 300 mm
Output 300 W
Equipped with a thermostat
Strongly adherent glue for attachment of the carpet
NOTE! Only a skilled craftsman is allowed to carry out electrical work for the
heater.
4 FULL-HYDRAULIC CONTROL
Crosscutting, automatic starting of the splitting and operation of the in-feed conveyor are
effortlessly controlled using the fully hydraulic joystick-valve.
4.1 Mastering the safety devices
While the protective net for the splitting chute is closed, access is prevented to the operat-
ing area of the crosscut saw-blade and the pusher. As the protective net for the splitting
chute is opened, the crosscut saw-blade cover is activated and the operation of the cross-
cut saw-blade, the pusher, the wood length adjuster (Palax Optimi) and the adjustment of
the splitting wedge are impeded.
4.2 Joystick-valve, Fig. 10
Push the joystick forward and move it in direction B - D; the conveyor feeds the log
against the log-stop.
Push the joystick forward and move it in direction B - C; the conveyor reverses.
Pull the joystick back in direction A; the saw-blade comes down and cuts through the
wood.
Push the joystick forward in direction B; the crosscut blade comes up and, at the same
time, launches the splitting.
To Next Page
Loading...