27 1-2017
Translation
9 MAINTENANCE OF THE MACHINE
NOTE ! Always use genuine spare parts prescribed by the manufacturer.
NOTE ! To clean up the guide rails for the pusher, drive the Palax Optimi once a
day to its extreme position (55 cm) and after that, return it to the desired cutting
length.
WARNING!
Always stop the machine and disconnect it from the power sources be-
fore performing any service measures.
9.1 Removal and change of the crosscut blade, Figs. 13 and 14
.
Figs. 13 and 14
The crosscut saw-blade must conform to the standard EN 847-1+A1.
1. Loosen the attachment screws for the protective cover, a 13 mm wrench.
2. Open the protective covers.
3. Loosen the blade-bolt using the special wrench delivered with the machine. Right-
hand thread, a 36 mm wrench
4. Carefully clean the surfaces of the flanges before re-installation of the blade.
5. The gap between the guide blocks and the blade must not be less than 5 mm.
NOTE ! While installing the blade, make sure that the locking pin (A) is in place!
To Next Page
Loading...