3 1-2017
Translation
CONTENTS
1.1
Foreword ............................................................................................................................... 5
1.2
EU Declaration of Conformity............................................................................................. 6
1.3
Intended use of the machine ................................................................................................... 7
1.4
Warning signs ......................................................................................................................... 7
1.5
Nameplates ........................................................................................................................... 9
1.6
The main dimensions and models of the machine ....................................................... 10
1.7
Safety instructions .............................................................................................................. 10
1.8
Noise emission and vibration ........................................................................................... 11
1.9
Responsibilities of the operator ....................................................................................... 11
1.10
Operating conditions ...................................................................................................... 12
1.11
Terms of warranty ........................................................................................................... 12
1.12
Operating instructions for the winch ............................................................................ 12
2
Taking delivery and setting up the machine for operation .......................................... 13
2.1
Lifting the machine ............................................................................................................. 13
2.2
The transport set-up and unpacking ............................................................................... 13
2.3
Acceptance inspection ...................................................................................................... 13
2.4
Main parts of the machine, Fig 1 ..................................................................................... 13
2.5
Bringing the table extension into the work position, Fig. 2 .......................................... 14
2.6
Bringing the conveyor into the work position, Figs. 3 and 4 ........................................ 14
2.7
Bringing the conveyor into the work position, Fig. 5 ..................................................... 15
2.8
Adjusting the cutting length, Fig. 6 .................................................................................. 16
3
Operation of the firewood processor powered by different power sources ............. 16
3.1
Testing the machine .......................................................................................................... 16
3.2
Powered by a tractor ......................................................................................................... 16
3.3
Suitable revolutions range for the PTO shaft ................................................................ 16
3.4
Disengagement lever for transmission, Fig. 7 ............................................................... 17
3.5
Required measures in an emergency situation ............................................................. 17
3.6
Starting under cold conditions (machine powered by a tractor) ................................. 17
3.7
Electric drive, start and emergency stop. ....................................................................... 17
3.8
Starting the electric motor using the Y/D starter, Fig. 8 ............................................... 18
3.9
Emergency stopping of an electrically powered machine, Fig. 8 ............................. 19
3.10
The machine is equipped with a system to prevent simultaneous operation in two
modes, Fig. 9 ................................................................................................................................ 19
3.11
Operation under cold conditions .................................................................................. 19
3.12
Electric heater for oil tank .............................................................................................. 20
4
Full-hydraulic control......................................................................................................... 20
4.1
Mastering the safety devices ............................................................................................ 20
4.2
Joystick-valve, Fig. 10 ....................................................................................................... 20
4.3
Other hydraulic operating controls, Fig. 11 .................................................................... 21
5
Use of the firewood processor, crosscut operation ..................................................... 23
5.1
Operating the crosscut saw, before the operation ........................................................ 23
5.2
During the operation .......................................................................................................... 23
To Next Page
Loading...