Palax C900 - Page 4

4 1-2017
Translation
5.3 Cutting to equal length and feeding into the splitting chute ........................................ 23
5.4 Feeding the last log for splitting ....................................................................................... 24
6 Disturbances during crosscut operation and their remedy ......................................... 24
6.1 Crooked trees ..................................................................................................................... 24
6.2 Big trees............................................................................................................................... 24
6.3 Cutting of small trees without splitting ............................................................................ 24
7 Disturbances during the splitting operation and their remedy .................................... 25
7.1 Stuck wood .......................................................................................................................... 25
7.2 Re-splitting the logs safely ................................................................................................ 25
7.3 If the log has fallen into the splitting chute in a wrong position .................................. 25
8 Accessories for the firewood processor......................................................................... 26
8.1 Splitting cylinder ................................................................................................................. 26
8.2 Automatic high-speed valve ............................................................................................. 26
8.3 Splitting wedges ................................................................................................................. 26
9 Maintenance of the machine ........................................................................................... 27
9.1 Removal and change of the crosscut blade, Figs. 13 and 14 ..................................... 27
9.2 Tightening the V-belts ....................................................................................................... 28
9.3 Replacement of the V-belts, centre shaft / saw-blade shaft ........................................ 28
9.4 Sharpening the blade, hard-metal blade ........................................................................ 28
9.5 Setting the saw-blade, hard-metal blade ........................................................................ 28
9.6 Spare blade ......................................................................................................................... 28
9.7 Replacement of V-belts, angular gear /centre shaft ..................................................... 28
9.8 Tightening the in-feed conveyor belt, Figs. 18 and 19 ................................................. 29
9.9 Replacing the in-feed conveyor belt ................................................................................ 30
9.10 Direction of rotation of the belt ...................................................................................... 30
9.11 Changing the oil in the angular gear ............................................................................ 30
9.12 Change of the hydraulic oil ............................................................................................ 31
9.13 Lubricating the machine: refer to the Maintenance Schedule ................................. 31
9.14 Servicing the main valve, Fig. 26 ................................................................................. 32
9.15 Structure of the detent end and the correct order of the parts, Fig. 27 .................. 33
9.16 Tightening and lubrication of the conveyor chain ...................................................... 33
9.17 Cleaning the conveyor ................................................................................................... 33
9.18 Washing the machine .................................................................................................... 33
9.19 Storing the machine. ...................................................................................................... 33
10 Maintenance schedule ..................................................................................................... 34
11 Malfunctions and their remedy ........................................................................................ 35
12 Electric diagrams ............................................................................................................... 36