EasyManuals Logo

Palfinger RC 400 P2 User Manual

Palfinger RC 400 P2
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
Remote operation
38
Working or transport position of the rope winch
small large
In order to adjust the rope winch to working or transport position, keep toggle key (1, release)
depressed while simultaneously pressing the respective toggle key (2, a=transport position, b=working
position). Reaching of the respective position is confirmed by an acoustic signal.
Changing the radio channel (in the event of a radio
interference)
Briefly press key (3) 2x. If change of channel has been successful, this is indicated by an acoustic
signal. 12 channel frequencies are available.
Cable operation
A 15m long cable is supplied with each system. This cable must be connected to the transmitter and
the receiver. During cable operation no radio signals are transmitted, because cable operation has a
higher priority than radio operation. When the battery is inserted it will be automatically charged as
well.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Palfinger RC 400 P2 and is the answer not in the manual?

Palfinger RC 400 P2 Specifications

General IconGeneral
BrandPalfinger
ModelRC 400 P2
CategoryRemote Control
LanguageEnglish

Related product manuals