EasyManuals Logo

Pall Allegro MMG403 User Manual

Pall Allegro MMG403
53 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
7
4. Specifications
Table 1: Specifications
Footprint WxLxH:
40 x 114 x 89 cm (15.75 x 45 x 35 in.) - compact configuration
40 x 135 x 89 cm (15.75 x 53 x 35 in.) - extended configuration
Control box, cart, & mixer
enclosure material:
304 L stainless steel
Control box, Frame, Drive Box
surface finish
At least 1.2 μm Ra/ 47 μin Ra
Control box ingress rating:
IP 65
Drive Unit enclosure ingress
rating:
IP 23
Voltage:
100230 VAC, 50/60 Hz,
Voltage fluctuation:
+/- 10%
Overvoltage Category:
II
Input Wattage:
Less than 250 W
Amperage:
100 V 2.2 A; 110 V 2.0 A; 230 V 1.0 A
Altitude rating:
1000 m
Operating environment:
Temperature 4-40°C, Max humidity 85%, avoid condensation
Pollution degree:
2 or better
Motor horsepower:
¼ hp
Power cord length:
600 cm (20 ft)
Power cord plug options:
US, Continental Europe, Swiss, Australia, Japan, UK
E-stop (present, yes/no, location):
Yes, face of control box
Minimum & maximum speed:
20 to 300 RPM
Connectors for remote control:
TURCK RSFPV61; RSFPV579; HUMMEL M23 male thread,
12-pin.
Cord sets for remote control are not supplied
Functions available from remote
control panel:
Motor start, stop
Speed adjustment, indication
Alarm indication
Mode of control (remote/local) indication
Signal type(s) for remote
output/control:
Rotation speed out 4-20 mA, motor control in 0-10 V, discrete I/O
signals relay contact type
Alarms generated:
Motor failure, speed off-range failure, E-stop activation
Operator interface type:
Touchscreen PLC
Noise level at operator position:
63 dB
Casters:
2x swivel (front), 2X stationary (rear)
Wheel material:
Polyurethane
Recipe storage:
Yes. Up to ten can be stored. Up to ten instructions in each recipe
are executed sequentially. Each instruction contains individual
programmable parameters: mixing time, pause time, and speed.
Password protection:
Operator level: access to protected function - start recipe run.
Supervisor level: access to protected functions - Recipe Editor,
Pause or Abort Recipe run, Switch of Control between Local to
Remote, adjustment of set up for reduced set of parameters.
Maintenance level: access to protected functions Program Setup
parameters, System parameters and includes Supervisor level of
access.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pall Allegro MMG403 and is the answer not in the manual?

Pall Allegro MMG403 Specifications

General IconGeneral
BrandPall
ModelAllegro MMG403
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals