12/1/99
5-4 Clearing Data
The SITE Sub-Menu
(cont.)
When all of the stored site files have been cleared or the [EXIT] key
has been pressed at the
SITE NAME prompt, the programming
sequence resumes at this point.
The LOG Sub-Menu Use the LOG sub-menu to clear log files from the Model GF868’s
memory. Press the appropriate side of the
[SCREEN] key to activate
the desired pane of the data display screen, and refer to Figure A-7 on
page A-7 of Appendix A, Menu Maps, while completing the
following steps:
CLEAR Start
Press [F1]-[F3] to enter one of the
sub-menus or press the
[EXIT]
key to return to the data
measurement display.
CLEAR
Clear Site
TOTAL SITE LOG
Ch1 Channel Label site file É
The default power up screen is in
BIG mode. Access the Clear
Menu by pressing the
[CLR] key.
Velocity Ft/s
6.95
(error codes appear here)
VEL VOLUM +TOTL -TOTL
OPEN Start
Enter the assigned password and
press
[ENT]. If the security
feature has been deactivated, this
prompt does not appear. See
Chapter 1, Programming Site
Data, for details.
ENTER PASSWORD
Password
CLEAR Start
Press [F3] to select the LOG
option.
CLEAR
previous selection appears here
TOTAL SITE LOG
To Next Page