910-257C March 2006
Page 5-2 MG2 Series
• Receive previously transmitted thickness data back from a
computer
• View current datalogger settings while simultaneously taking
measurements.
You can store thickness measurements. When each measurement is
stored, the gage also stores a complete description of the measurement
conditions. The additional data stored with each thickness value
includes:
•File Name
• Identifier
• Units (in or mm)
• LOS (Loss of Signal)
• Differential Mode
• Differential Reference Value
•Alarm Mode
•Alarm Status
• Alarm Set Points
• Minimum or Maximum Mode
• Minimum or Maximum Reading
• Velocity
• Resolution
• Transducer Setup Number and Information
• Coating Thickness (when THRU-COAT
®
is active)
You can store a maximum of 8,000 thickness values at any one time in
the MG2-DL.
To Next Page