Troubleshooting
Starting up
During operating
Symptom Confirmation Details
Power does not come on. • Is the camera cable connected correctly?
Refer to the connections on page E-7.
Unusual sound is heard. • Some operating sounds may be evident when
powering on, switching IR modes and zooming.
Sounds in such cases do not necessarily
indicate a problem.
Symptom Confirmation Details
Video is distorted or not
recorded.
(Refer to the Operating Instructions of the Remote
Control Panel.)
• Are camera and video monitoring equipment
connected properly?
• Are both the video input connector selection
and the input selection made with the Remote
Control Panel the same?
• Are the video output settings correct for the
connected equipment? Connect a monitor to
the [VIDEO OUT] connector on the rear panel
of the Memory Card Video Recorder and check
the picture.
Recorded video is in black
and white.
• The IR function was enabled, which results in a
B/W picture.
Focusing does not work. •
Are you attempting to record video of scenes that
are hard to focus? In the following conditions,
focusing may be difficult.
examples are listed below:
• The field of view includes both distant and
near objects.
•
The camera is shooting through dirty window glass.
• Ambient lighting is low.
•
There are bright and reflective surfaces around
the object.
•
The camera is shooting a rapidly moving object.
• The object has little contrast.
•
A close-by object is being shot at high zoom ratio.
• The camera can also be focused manually. For
details, refer to the Operating Instructions of the
Remote Control Panel.
E-9
To Next Page
Loading...
