Firmware Ver. 1.4 — Configuration Menu Added for Focus Ring Operations
- F 8 -
Configuration Menu Added for Focus Ring Operations
[FOCUS RING DRIVE]
[CAMERA] menu [SW MODE] [FOCUS RING DRIVE]
Switches the way focus is adjusted with the focus ring.
≥ Also set [FOCUS RING SETTING].
(Factory setting: [NON-LINEAR])
[FOCUS RING SETTING]
[CAMERA] menu [SW MODE] [FOCUS RING SETTING]
¥ When [FOCUS RING DRIVE] is set to [NON-LINEAR]
Sets the way focus is adjusted with the focus ring.
(Factory setting: [SPEED])
¥ When [FOCUS RING DRIVE] is set to [LINEAR]
Sets the rotational angle of the focus ring.
The items that can be set are as follows.
≥ [90°], [120°], [150°], [180°], [210°], [240°], [270°], [300°], [330°], [360°]
(Factory setting: [180°])
[NON-LINEAR] The focus value changes according to the rotational speed and rotational position of the focus ring.
[LINEAR] The focus value changes according to the rotational angle of the focus ring.
[SPEED] Adjusts the focus value according to the speed at which the focus ring is rotated.
[COARSE] Adjusts the focus value according to the rotational position of the focus ring.
Since the operation of the focus ring results in a greater change in focus value, this setting is suitable for making rough
adjustments.
[FINE] Adjusts the focus value according to the rotational position of the focus ring.
Since the operation of the focus ring results in a smaller change in focus value, this setting is suitable for making fine adjustments.
To Next Page
Loading...
