Panasonic AG-DVX100B - Regular Shooting; Preparation and Inspections; Shooting in Auto Mode

31
5.2 RECORDING SETUP Screen
(Same Menu used for the Camera, some functions not used)
Rec Speed
allows the user to select the recording time, either SP for standard play or LP
for long play
Audio Rec
used for selecting the method of recording audio, 12 bit (12bit/32kHz) or 16 bit
(16 bit/48kHz)
1394 TC Regen
This item is used to select the time code that will recorded from the DV
connector.
OFF:
The signal recorded will use the time code set up using the TC MODE item, TCG
item and the First REC TC item.
ON: The signal recorded will use the time code from signal being recorded from the DV
connector.
Note: When ON is used, it will take precedence over TC MODE item, TCG item and the
First REC TC item. If no Time code is supplied to the DV connector, TC MODE item, TCG
item and the First REC TC item will be used.
TC Mode
this item selects DF (Drop Frame) or NDF (Non-drop Frame) modes and as
explained earlier this item corrects for timing differences.
Note: When the progressive mode, 24P or 24P ADV is used, the non drop frame mode is
set regardless of the setting. See more information about Time Code on page 21
Item Settings Default
REC SPEED SP / LP SP
AUDIO REC 12bit / 16 bit 16bit
1394 TC REGEN OFF / ON ON
TC MODE DF / NDF -50dB
TCG FREE RUN / REC RUN -50dB
FIRST REC TC REGEN / PRESET DF
TC PRESET INPUT START OF TIME CODE - - - -
1394 UB REGEN OFF / ON OFF
UB MODE USER, TIME, DATE, TCG, FRM
RATE
USER
UB PRESET USER bit - - - -