27
4.6 OTHER FUNCTIONS Screen
Remote
This item is used to set the operations of the wireless remote control. There are
3 settings, VCR1, VCR2 and OFF. When using two DVX-100’s this setting allows the two
camcorder to be control from one remote control, by selecting which camcorder you want to
control from the remote control. This item makes sure that only that one button (VCR1 or
VCR2) will operate this camcorder from the remote control. OFF the remote will not be able
to control the camcorder.
IEEE 1394
Or firewire as it is often called is an extremely high speed, high performance
Serial Bus with a special protocol (set of rules). Part of that protocol has been used for high
speed digital video and audio transfer. Not only can you transfer video and audio, you can
transfer time code and control your VCR remotely. The cable used must not be longer then
4.5 meters.
DV Control:
This item selects the method for backup recording, using the DV (1394)
connector located on the side, under a cover of the DVX-100. There are 4 selections:
OFF:
There is no control information supplied.
EXT: The START/STOP button will control the backup recording. In this mode only the
backup recorder will record the video and audio. The camcorder does not record.
BOTH: The video is recorded on both the camcorder and the backup unit.
CHAIN: used when additional record time is needed. Once the camcorder approaches the
end of its record time the backup unit will automatically start recording. Remember the back
up unit must be in the record standby mode to function.
Item Settings Default
REMOTE VCR1, VCR2, OFF VCR1
DV CONTROL OFF, EXT, BOTH, CHAIN OFF
DV CMD SEL REC P / STOP REC P
REC LAMP OFF, FRONT, REAR, BOTH OFF
BEEP SOUND OFF / ON OFF
CLOCK SET SETS INTERNAL CALENDAR YES
TIME SHIFT +23h, +1h, OFF, -1h, 23h OFF
TAPE PROTECT POWER OFF / STBY POWER OFF
USER FILE LOAD, SAVE, INITIAL - - - -
HOUR METER VIDEO HEAD HOUR METER 00000H
To Next Page
Loading...
