30
5. VCR
5.1 PLAYBACK FUNCTIONS Screen
End Search
This item sets up the operation of the END SEARCH button when pressed.
BLANK: In this mode the END SEARCH will look for any blank spaces on the videotape.
Rec End: In this mode the END SEACH will look for the video that was shot last.
Note: When placed in the Rec End function and a new videotape is used, this function will
not operate correctly. If the tape is blank the operation will stop at the end of the tape.
12 bit Audio
When making a recording in the 12 bit audio mode, this item will choose the
audio Channels being used..
There are three selections:
ST1: CH1 signals are recorded on Channel 1 track
CH2 signals are recorded on Channel 2 track
ST2: CH1 signals are recorded on Channel 3 track
CH2 signals are recorded on Channel 4 track
MIX:
CH1 signals are recorded on Channel 1 and Channel 3 tracks
CH2 signals are recorded on Channel 2 and Channel 4 tracks
NOTE: If the audio has been recorded in the 16 bit mode, there will be no Channel 3 or
Channel 4. In this mode there will only be:
CH1 signals are recorded on Channel 1 track
CH2 signals are recorded on Channel 2 track
Audio Out
used to set the audio signals that are sent to the RCA connectors when the
videotape is played back.
CH1
y
CH2 Channel 1 Connector has Channel 1 audio signals
Channel 2 Connector has Channel 2 audio signals
CH1 Channel 1 Connector has Channel 1 audio signals
Channel 2 Connector has Channel 1 audio signals
CH2 Channel 1 Connector has Channel 2 audio signals
Channel 2 Connector has Channel 2 audio signals
Item Settings Default
END SEARCH BLANK / REC END BLANK
12 bit AUDIO ST1, ST2, MIX ST1
AUDIO OUT CH1-CH2, CH1, CH2 CH1-CH2
To Next Page
Loading...
