29
Tape Protect
When the unit has been left in standby for 5 minutes while in the record
pause mode, it will be automatically be set to the tape protection mode. There are two
choices for this tape protection mode: POWEROFF which shuts off the power and STBY,
which only places the video heads in the stop mode.
User File
This item has three settings:
Load: which will load the last settings stored in the user file.
Save: this item allows the user to save any settings that have been changed.
Initial:
this item allows the user to re-install the factory settings.
Note:
When the LOAD or INITIAL operation has been performed, turn the power OFF and
then ON in order to enable the settings.
Hour Meter
This item keeps a record of total hours that the video head has been rotat-
ing, this is a 5 digit number, measured in 1 hour increments.
To Next Page
Loading...
