VTR
Send command
Return (completion)
operation
message
Supplementary notes
SHTL
FORWARD
[STX] OSF:data [ETX]
[STX] OSF [ETX]
This is the forward direction shuttle command.
data =
n: speed data
0: STILL
1: ×0.03
(DVCPRO), ×0.03
(DV, DVCAM)
2 : ×0.1
(DVCPRO),
×0.1 (DV, DVCAM)
3 : ×0.2
(DVCPRO),
×0.3 (DV, DVCAM)
4 : ×0.5 (DVCPRO), ×0.5 (DV, DVCAM)
5: × 1 (DVCPRO),
×1
(DV, DVCAM)
6: ×1.85 (DVCPRO),
×1.85
(DV, DVCAM)
7 : ×4.1
(DVCPRO), ×3.1
(DV, DVCAM)
8 : ×9.5 (DVCPRO),
×9.5
(DV, DVCAM)
9 : ×16 (DVCPRO), ×16
(DV, DVCAM):
This speed differs according to the setting
selected for set-up menu No.101 (SHTL
MAX).
A: ×32
(DVCPRO),
×32
(DV, DVCAM):
This speed differs according to the setting
selected for set-up menu No.101 (SHTL
MAX).
SHTL
REVERSE
[STX] OSR:data [ETX] [STX] OSR [ETX]
This is the reverse direction shuttle command.
data =
n: speed data
0: STILL
1: ×0.03
(DVCPRO), ×0.03 (DV, DVCAM)
2: ×0.1 (DVCPRO),
×0.1
(DV, DVCAM)
3: ×0.2 (DVCPRO), ×0.3
(DV, DVCAM)
4: ×0.5 (DVCPRO), ×0.5
(DV, DVCAM)
5: ×1 (DVCPRO),
×1 (DV, DVCAM)
6: ×1.85 (DVCPRO), ×1.85
(DV, DVCAM)
7: ×4.1 (DVCPRO), ×3.1
(DV, DVCAM)
8: ×9.5 (DVCPRO), ×9.5
(DV, DVCAM)
9: ×16 (DVCPRO), ×16
(DV, DVCAM):
This speed differs according to the setting
selected for set-up menu No.101 (SHTL
MAX).
A: ×32 (DVCPRO), ×32
(DV, DVCAM):
This speed differs according to the setting
selected for set-up menu No.101 (SHTL
MAX).
STANDBY
OFF
[STX] OBF [ETX]
[STX] OBF [ETX]
This command is for setting the VTR to standby OFF.
STANDBY
ON.
[STX] OBN [ETX] [STX] OBN [ETX]
This command is for setting the VTR to standby ON.
– E-11 –
To Next Page
Loading...
