14
General: Color TV Standard Settings (Settings for frame frequency)
The unit is delivered with the color TV standard not yet specified. To revise the settings for frame frequency according to the
preferred standard, refer to the procedures described below.
1 After connecting the unit to the power supply and then
turning on the power, press the MENU button while
pressing the LIGHT button to open OPTION MENU.
2 Turn the jog dial button to move the cursor (arrow) to the
AREA SELECT item on the <AREA SETTING> screen
in OPTION MENU page, and then press the jog dial
button.
3 Select the area among NTSC, NTSC (J), and PAL. After
selecting the area by turning the jog dial button, press
the jog dial button.
4 Move the cursor (arrow) to ! AREA SET by turning the
jog dial button, and then press the jog dial button. The
following window appears.
5 Move the arrow (!) to YES and press the jog dial
button. The settings selected in step 3 above are
reflected in FACTORY and CURRENT data.
6 Turn off the power supply once and then turn on it again.
#Notes
" The settings are not saved unless AREA SET is executed
even if NTSC, NTSC (J), or PAL is selected in the AREA
SELECT.
" When AREA SELECT is revised, the “! AREA SET”
blinks.
" When these items are set when the unit is used for the first
time, only the following 8 items are revised. When the
other settings of the unit are set in MAIN MENU, the menu
setting values for items other than the following 8 are ones
that were set at the factory.
*1 Select THUMBNAIL ! SETUP ! DATE FORMAT from the
thumbnail menu. For details refer to [Setting the Thumbnail
Display Mode] (page 142).
Color TV Standard Settings
(Settings for frame frequency)
To Next Page
Loading...
