Panasonic AJ-HPX3700G - Page 199

199
Menu: Menu Description Tables
Menu
MIC/AUDIO2
Items/
Data Saved
Adjustable
Range
Remarks
FRONT MIC
POWER
ON
OFF
Select the phantom power supply for the
front microphone.
– C U F –
REAR MIC
POWER
ON
OFF
Select the phantom power supply for the
rear microphone.
When “OFF” is selected, no phantom
power is supplied even if the LINE/MIC/
+48V selector switch is set to [+48V].
– C U F –
MONITOR
SELECT
STEREO
MIX
When the MONITOR select switch is set
to [ST] (stereo), select the signal format
for the monitor output.
– C U F –
FRONT MIC
LEVEL
–40dB
–50dB
Select the front microphone input level.
– C U F –
REAR MIC CH1
LVL
–50dB
–60dB
Select the rear microphone input level.
– C U F –
REAR MIC CH2
LVL
–50dB
–60dB
Select the rear microphone input level.
– C U F –
REAR LINE IN
LVL
0dB
+4dB
–3dB
Select the rear line input level.
– C U F –
AUDIO OUT LVL 0dB
+4dB
–3dB
Select the audio output level.
– C U F –
HEADROOM 18dB
20dB
Set the headroom (standard level).
– C U F –
WIRELESS
WARN
ON
OFF
Select whether or not to enable the
alarm to trigger for poor wireless receiver
reception.
– C U F –
WIRELESS
TYPE
SINGLE
DUAL
Select the type of wireless receiver.
SINGLE:
Select a single channel wireless
receiver.
DUAL: Select a 2-channel wireless
receiver.
– C U F –
TC/UB
Items/
Data Saved
Adjustable
Range
Remarks
TC MODE DF
NDF
Set the time code mode.
DF: Drop frame.
NDF: Non drop frame.
#Note
When the unit operates at 50 Hz or in
24P or 24PA mode, the non-drop frame
is always used.
– C U F –
UB MODE USER
TIME
DATE
EXT
TCG
FRM RATE
REGEN
Select the user bits mode.
USER: Select UB value set in the LCD
section.
TIME: Select local time (hours,
minutes, seconds).
DATE: Select local date and time (2 last
digits of year, month, date, time).
EXT: The user bits input to the TC IN
connector are recorded.
If reading fails, USER value is
retained.
TCG: TCG value enters UB.
FRM RATE:
Select the shooting information
(e.g. frame rate) for the camera.
For more information, see
[Frame rate information
recorded in user bits] (page 66).
When clips recorded in native
mode are played back, the frame
rate information recorded in
users bits in the VAUX area is
output.
REGEN: Read out value stored in the
card and record value
continuously.
– C U F –
!"#$%&'())*#+,-.+/012345677899.QQ9:;<99=>>?@A>BACDEFGDEHIJKL?M