Panasonic AK-HC3500ES - Page 33

33
Table of adjustment setting ranges
Operation
Menu Item Adjustment setting range Initial value Items recorded on SD memory cards
VF Setting1
Side Modu SW OFF, ON OFF

No switching from the SD memory
card to the camera settings possible
while the buildup unit is connected.
Side Modu LVL 0 to
31 31

No switching from the SD memory
card to the camera settings possible
while the buildup unit is connected.
Zone Mark OFF
, 4:3, 13:9, 14:9, 15:9, 16:9 OFF

No switching from the SD memory
card to the camera settings possible
while the buildup unit is connected.
Safety Mark1 16:9, 15:9, 14:9, 1
3:9, 4:3, OFF OFF

Safety Area1 80 %, 90 %, 9
3 %, 100 % 80 %

Saf
ety Mark2 16:9, 15:9, 14:9, 13:9, 4:3, OFF OFF

Saf
ety Area2 80 %, 90 %, 93 %, 100 % 93 %

Center Mark OFF, ON OFF

Center Mark SEL 1 to 8 1

Line Width 1 to
3 2

Marker Level 100 %, 75 %, 50 % 100 %

VF Setting
2
VF DTL 0 to
23 10

RET Signal
HD Peak FREQ Low, Mid, Hi Mid

HD Offset Gain 0 to 5 0

HD Crisp 0 to 6
3 0

D1 Peak FREQ 2
.0M, 2.3M, 2.7M, 3.4M, 4.5M, 6.8M, 13M 6.8M

D1 Offset Gain 0 to 5 0

D1 Crisp 0 to 6
3 0

VBS Peak FREQ 2
.0M, 2.3M, 2.7M, 3.4M, 4.5M, 6.8M, 13M 6.8M

VBS Offset Gain 0 to 5 0

VBS Crisp 0 to 6
3 0

Cursor
Cursor OFF, ON OFF

Cursor Memory ADJ
, 1, 2, 1+2 ADJ

H Position 0 to
255 127
V Position 0 to
255 127
Width 0 to
255 127
Height 0 to
255 127
BOX/CROSS BOX, CROSS BOX
Store Memory MEM1, MEM
2 MEM1
EXECUTE NO?, YES?
VF Display1
F Number OFF, ON OFF

Zoom OFF, ON OFF

Focus OFF, ON OFF

Extender OFF, ON OFF

MONI OUT OFF, ON OFF

Filter OFF, ON OFF

M Gain OFF, ON OFF

Shutter OFF, ON OFF

5600K OFF, ON OFF

Audio Level OFF, ON OFF

VF Displa
y2
OPT Level OFF, ON OFF

RET Select OFF, ON OFF

Status OFF, ON OFF

Status(AUTO) OFF, ON OFF

Field Rate OFF, ON OFF

Voltage OFF, ON OFF

WFM (*1) OFF, ON OFF

White CH OFF, ON OFF

Setting1 FAN Power OFF, ON, AUTO ON
FAN Mode LOW, NORM NORM
CALL+R_TALLY OFF, ON OFF

CALL+T_TALLY OFF, ON OFF

PinP Mode — —
*1:
Waveforms are displayed as a single line at the centre of the screen. They appear at the bottom right when the aspect ratio is set
to 16:9, but when an aspect ratio of 4:3 is set on the viewfinder or when the side panel mode is selected by the down-converter, the
waveform display will be cut off in part.