Item Setting details
MIC1 LINE LV Adjusts the level for input to the camera's <MIC 1> connector.
MIC1 AMP Makes fine adjustments of the MIC1 gain.
(1 dB increments)
MIC2 GAIN Makes coarse adjustments of the MIC2 gain.
MIC2 LINE LV Adjusts the level for input to the camera's <MIC 2> connector.
MIC2 AMP Makes fine adjustments of the MIC2 gain.
(1 dB increments)
SHOOTING MODE Sets the shooting mode.
CAM FAN Sets the camera's cooling fan operation.
TALLY GUARD When set to ON, this function disables automatic ASU, AWB, ABB operation while the tally is ON.
ASU FILTER Sets the operation of the ND/CC filter when auto setup is started.
REF
The filter stored in the reference file is used when operation starts.
CURRENT
Auto setup starts at the filter position made prior to startup.
ASU MODE Selects the auto setup mode setting.
ASU M. PED TARGET Sets the position where the master pedestal is to be converged when auto setup is started.
ASU REF.FILE Specifies the reference file used during auto setup.
REF.RECALL Sets the reference file that is recalled when the [REF. RECALL] button is pressed.
CABLE CONNECT Displays the CCU connection cable setting. You can change the setting via menu operations on the
camera itself.
HYBRID
Indicates that the CCU is connected via an optical fiber multi cable.
FIBER
Indicates that the CCU is connected via an optical fiber cable.
CTRL ROTATION A mode that operates based on the numerical value and a mode that operates based on the effect are
available. For details, refer to the operating instructions of the camera.
TALLY CONTROL Sets whether or not to notify the camera when there is a tally input from the <PREVIEW> connector.
When this set to “ON”, notification is sent if there is a tally input when the camera set in [TALLY INPUT] is
selected.
This is enabled when other than “Serial”, “LAN”, “Serial(AK)”, and “LAN(AK)” is set in [CONNECT
SETTING].
TALLY INPUT Sets the camera to be notified of a tally input when [TALLY CONTROL] is set to “ON”.
This is enabled when other than “Serial”, “LAN”, “Serial(AK)”, and “LAN(AK)” is set in [CONNECT
SETTING].
- 104 -
ROP menu
To Next Page
Loading...
