Installing and removing rack mount brackets
The unit is shipped from the factory with the rack mount brackets installed.
The customer can remove the four screws that hold the rack mount brackets in place using a Phillips screwdriver.
A. Rack mount bracket
B. Securing screws
After detaching, store the rack mount brackets and the screws in a location easily accessible when required.
The next time you use the rack mount brackets to secure the unit, tighten the four screws to a torque of 50 N•cm or more.
Rack installation (rack mounting)
Secure the unit to the rack using two securing screws.
The securing screws are not supplied with the unit. Purchase screws that will fit the φ5 mm (3/16 inch) in diameter holes before
rack mounting.
The temperature in the rack must be between 0°C (32°F) and 40°C (104°F).
A. Securing screws (commercially available)
- 15 -
Introduction
To Next Page
Loading...
