Panasonic AK-HRP1000G

Item Setting details
ROP IP ADDRESS Sets the IP address of the unit.
The setting ranges are as follows.
(Factory default: 192.168.0.130)
1st octet: 1 to 223
2nd octet: 0 to 255
3rd octet: 0 to 255
4th octet: 1 to 254
However, the following addresses cannot be set.
Check the setting values during configuration.
0.*.*.*, *.*.*.0, *.*.*.255, 127.0.0.1
Class D address (224.0.0.0 to 239.255.255.255)
Class E address (240.0.0.0 to 255.255.255.255)
ROP PORT Sets the port of the unit.
Values from 35200 to 35599 can be set.
(Factory default: 35200)
UPLOAD When you press the [MENU] dial, the unit's IP address and port will be set.
ROP SUBNET MASK Sets the subnet mask of the unit.
The follow values can be set.
(Factory default: 255.255.255.0)
1st octet: 128, 192, 224, 240, 248, 252, 254, 255
2nd octet: 0, 128, 192, 224, 240, 248, 252, 254, 255
3rd octet: 0, 128, 192, 224, 240, 248, 252, 254, 255
4th octet: 0, 128, 192, 224, 240, 248, 252, 254, 255
UPLOAD When you press the [MENU] dial, the unit's subnet mask will be set.
ROP DEFAULT GATEWAY Sets the default gateway of the unit.
The setting ranges are as follows.
(Factory default: 192.168.0.1)
1st octet: 1 to 223
2nd octet: 0 to 255
3rd octet: 0 to 255
4th octet: 1 to 254
However, the following addresses cannot be set.
Check the setting values during configuration.
0.*.*.*, *.*.*.0, *.*.*.255, 127.0.0.1
Class D address (224.0.0.0 to 239.255.255.255)
Class E address (240.0.0.0 to 255.255.255.255)
UPLOAD When you press the [MENU] dial, the unit's default gateway will be set.
MAC ADDRESS Display the unit's MAC address. (Display only)
NOTE
Performing [UPLOAD] after changing the settings will store the setting value changes to the internal memory. Perform [UPLOAD]
on each screen. The setting values stored to memory will be applied after the unit is restarted.
- 117 -
ROP menu