Panasonic AU-EVA1 - Page 91

91
6-5. Troubleshoot (INVALID error message)
Following tables show major causes and ways to cope with “INVALID” error message.
When occurred?
Cause
Remedy
Tapped the LCD
screen to set SDI OUT
color to "V-Log" (or
"V-709"). See P.13 for
the details.
MAIN COLOR setting is NOT set to
V-Log.
Set SYSTEM SETTINGS > COLOR SETTINGS > MAIN >
V-Log.
SDI RAW output mode is being
turned ON.
Set SYSTEM SETTINGS > SYSTEM MODE >SDI RAW > OFF
Tapped the LCD
screen to set HDMI
OUT color to "V-Log"
(or "V-709"). See P. 13
for the details.
MAIN COLOR setting is NOT set to
V-Log.
Set SYSTEM SETTINGS > COLOR SETTINGS > MAIN >
V-Log.
Tapped the LCD
screen to set LCD
OUT color to "V-Log"
(or "V-709"). See P. 13
for the details.
MAIN COLOR setting is NOT set to
V-Log.
Set SYSTEM SETTINGS > COLOR SETTINGS > MAIN >
V-Log.
Pressed a user button,
Color bars assigned.
SDI RAW output mode is being
turned ON.
Set SYSTEM SETTINGS > SYSTEM MODE >SDI RAW > OFF
Pressed a user button,
OPEN IRIS FOCUS
ASSIST assigned.
The EVA1 is currently recording (on
built-in recorder and/or external
recorder connected via SDI, HDMI.
The function cannot be turned ON/OFF while recording. Stop
recording and try again.
Pressed a user
assignable dial to turn
ON/OFF variable
frame rate (VFR)
function.
The EVA1 is currently recording (on
built-in recorder and/or external
recorder connected via SDI, HDMI.
The VFR function cannot be turned ON/OFF while recording.
Stop recording and try again.
Record format is being set to one of
the AVCHD formats.
Set SYSTEM SETTINGS > SYSTEM MODE > MAIN CODEC >
"any format" except for AVCHD PS, AVCHD PH, AVCHD HA,
AVCHD PM.
Record format is being set to
interlace format (59.94i or 50i).
Set SYSTEM SETTINGS > SYSTEM MODE > FREQUENCY >
any progressive format.
6. Appendix