Notify of alarm occurrences to the designated IP addresses (Panasonic
alarm protocol notification)
This function is available only when a Panasonic device, such as the network disk recorder, is connected to
the system. When “On” is selected for “Panasonic alarm protocol”, the connected Panasonic device will be
notified that the camera is in the alarm state. The settings for Panasonic alarm protocol can be configured in
the Panasonic alarm protocol section of the [Notification] tab of the [Alarm] page. (®page 88)
Operating Instructions 31
3 Action at an alarm occurrence
To Next Page
Loading...
