• Close: The alarm output terminal will close when outputting the alarm signals. (Normally open)
• Default: Close
Note
• When “Open” is selected, the alarm signal will be output for about 20 seconds when the power of the
unit is turned on.
[Pulse width]
When “Pulse” is selected for “Alarm output”, select an alarm output terminal duration from the following.
• Available range: 1-120s
• Default: 1s
11.5 Change the AUX name [Alarm] (BL-VT164W/
BL-VT164)
Click the [Alarm] tab on the “Alarm” page. (®page 34, page 35)
The names of “AUX”, “Open” and “Close” on the “Live” page can be changed.
AUX title
[AUX (Up to 10 characters)]
Enter the name for “AUX” on the “Live” page.
• Unavailable characters: " &
• Default: AUX
[Open (Up to 5 characters)]
Enter the name for “Open” of “AUX” on the “Live” page.
• Unavailable characters: " &
• Default: Open
[Close (Up to 5 characters)]
Enter the name for “Close” of “AUX” on the “Live” page.
• Unavailable characters: " &
• Default: Close
Note
• AUX is a camera terminal that allows users to operate (Open/Close) arbitrarily from the “Live” page.
For example, an operator can remotely control lights in a place where the camera is installed by
connecting the terminal to the light controller.
Operating Instructions 83
11 Configure the alarm settings [Alarm]
To Next Page
