Panasonic BT-S1315DA - Disassembly Instructions

file:///E:/BT-S1315DA_BT-S1315DAD_BT-S1415DA_BT-S1415DAD/SVC/s0200000000x.html
2 Disassembly Instructions
TOP PREVIOUS NEXT
Warnings:
Be sure to unplug the AC power cord from the AC power outlet before disassembling this monitor.
Cautions:
When turning over a printed circuit board, be sure to put a insulating material under it to prevent a
short circuit.
Printed circuit boards and wires must not be pulled forcibly, but be handled carefully.
Connectors also must be handled carefully.
After repairing this monitor, be sure to put back the wires and connectors to the original conditions.
When removing the rear panel, take care not to damage the neck of the picture tube.
Note:
After replacing any P.C. Board with a new one, be sure to check the picture quality. If there is a
problem, adjust the items related to its problem according to the chapter "Measurements and
Adjustments".
2.1 Printed Circuit Board Layout
2.2 Removal of Top Cabinet
2.3 Removal of Rear Cover
2.4 Removal of DS-P.C.Board (for BT-S1315DAD/S1415DAD only)
2.5 Removal of B- andW-P.C.Boards
2.6 Removal of A-P.C.Board
•@
file:///E:/BT-S1315DA_BT-S1315DAD_BT-S1415DA_BT-S1415DAD/SVC/s0200000000x.html (1 z 2) [2006-02-04 08:28:15]