file:///E:/BT-S1315DA_BT-S1315DAD_BT-S1415DA_BT-S1415DAD/SVC/s0408020000.html
4.8.2 Adjustment Procedure
TOP PREVIOUS NEXT
1. Input a crosshatch pattern signal.
2. Adjust the 4-pole magnet to merge the blue lines with the red ones in the middle section of the
screen.
Note:
3. For the location of the magnets, refer to the chapter 3 Picture Tube Replacement.
4. Adjust the 6-pole magnet to merge the green lines with the red and blue ones merged in step 2
in the middle section of the screen.
5. Fine-tune the deflection yoke position to adjust the convergence in the entirety of the screen.
6. Secure the deflection yoke with 3 wedges.
Warning:
7. Never locate the wedges within 25 mm of the end of the anode pad to prevent high-voltage
surges.
•@
TOP PREVIOUS NEXT
file:///E:/BT-S1315DA_BT-S1315DAD_BT-S1415DA_BT-S1415DAD/SVC/s0408020000.html [2006-02-04 08:28:37]
To Next Page
Loading...
