1.
On the desktop screen, right-click or on the tasktray, and click[Power Options].
2. Click [Choose what the power button does] - [Change settings that are currentlyunavailable].
3. Add check mark for [Hibernate] and click [Save changes].
C A U T I O N
While the computer is entering sleep or hibernation
n Do not:
Touch the keyboard, touchpad, screen, tablet buttons, or power switch.
Use an external mouse or other peripheral devices.
Connect or disconnect the AC adaptor.
Close or open the display
Insert and remove the SD Memory Card.
Wait untilthe power indicator blinks green (sleep) or goes off (hibernation).
n It may take 1 or 2 minutes to enter sleep or hibernation. Do not touch any key though the screen becomes dark.
n After releasing the power switch, do not operate it until the power indicator blinks or goes off.
If you pressand hold the power switch for longer than 4 seconds, the computer will forciblyshut down and unsaved data will be lost even if you
have set [When I pressthe power button] to any item in [Choose what the power button does] of [Power Options] in [Control Panel].
In sleep or hibernation
n Do not attach or remove peripheral devices. Doing so may cause malfunction.
n Power is consumed in sleep.
To resume from sleep or hibernation
1. Open the display, or press the power switch (A).
C A U T I O N
n Do not perform the following operations until resuming is complete. After the display is resumed, wait approximately 15 seconds (nor-
mally) or 60 seconds (when the computer is on a network).
Touch the keyboard, touchpad, screen, tablet buttons, or power switch.
Use an external mouse or other peripheral devices.
Connect or disconnect the AC adaptor.
Close or open the display.
Shut down or restart Windows.
Enter sleep or hibernation.
Insert and remove the SD Memory Card.
To Next Page
Loading...
