23
Multimedia Pocket
3 Press the release handle (B).
The release handle pops out.
4 Pull the release handle (B) to draw out the device partway, and hold
the device on its both sides to remove.
5 Carefully insert the device into the multimedia pocket by pushing
both corners until it surely fits in the slot.
z Press the release handle (C) to set in.
z You can insert the device with the computer turned on.
z Insert the device with the label side up.
6 Close the cover until it clicks.
CAUTION
z Hold the device by both sides. Otherwise the device may be damaged.
z Do not apply excessive force when raising the slot side upward and inserting the device.
NOTE
z You can see that the device is recognized or not by double-clicking
on the notification area, or checking the [Infor-
mation] menu in the Setup Utility (Î page 61). (When using a second battery pack, press
Fn
+
F9
.) If the device is not
recognized (or if the media cannot be accessed), turn off the computer and reinsert the device.
To Next Page
Loading...
