46
LAN
CAUTION
z Do not connect the telephone cable to the LAN port.
1 Turn off the computer.
z Do not use standby or hibernation.
2 Slide the latch (A) and open the cover, and connect the cable.
Connect the LAN port (B) and the network system (server, HUB, etc.) by using a
LAN cable.
3 Turn on the computer.
NOTE
z Even when a password is set in the Setup Utility and [Password on boot] is set to [Enable], entering the password is
unnecessary for turning on or resuming the computer.
z Connect the AC adaptor.
z The Power On by LAN function is off under the following conditions:
• When you turn the computer off by sliding the power switch for four seconds or longer (e.g., after a hung-up).
• When you reattach the AC adaptor and battery pack to the computer after removing them.
z The screen remains dark after the computer resumes from standby. The previous screen display will be restored when
you touch the keyboard, touch pad or touchscreen (only for model with touchscreen).
Connecting LAN
Power On by LAN/Wake Up from Wired LAN
To Next Page
Loading...
